How to define text_base in u-boot?

Asked by Dirty Francis

Report
in progress 103
6 Answers 184 views

Leave a reply to Dirty Francis : define text_base in u-boot


Answers ( 6 )

  1. Ashleigh

    Transcript. 1. U-boot startup sequence CCMA, ITRI houcheng 2. Agenda • U-boot introduction
    Read More

    Ratings : 13 %   

      
  2. Rebellious Oliver

    1. Abstract. This is the DENX U-Boot and Linux Guide to Embedded PowerPC, ARM and MIPS Systems. The document describes how to configure, build and use the firmware
    Read More

    Ratings : 73 %   

      
  3. Bloodsword Charles

    1 Install the tools; 2 Switch your device into FEL mode; 3 Boot the system over USB. 3.1 Mainline u-boot. 3.1.1 Getting the mainline u-boot sources; 3.1.2 Old method
    Read More

    Ratings : 48 %   

      
  4. Milly

    大多数bootloader都分为stage1和stage2两部分，u-boot也不例外。依赖于CPU体系结构的代码（如设备初始化代码等）通常都放在stage1且
    Read More

    Ratings : 26 %   

      
  5. Frosty Adam

    First you need to connect your phone without battery and then load usb driver windows, after install driver run bat file ,after few second ,phone repair done.
    Read More

    Ratings : 19 %